MUTOH ValueJet VJ-1324, Maintenance Manual, Page: 331 / 439

5.7.6 Uni-D/Bi-D Adjustment Menu P.5-45
5.7 Adjustment Menu VJ1324E-M-02
(2-c)Bi-D adjustment pattern
（
When Print2 is selected
）
1. Prints out the pattern on the basis of Nozzle line C. (Bi-D 320 VSD1)
2.
After printing patterns, enter adjust values under 'setup'.
"(2-e) Setup menu" p.5-47
3. After entering adjustment values, print again adjustment patterns, and check.
4. Repeat steps 1 through 3 until each connecting points matches.
㧭㨐㨖ޓ㧢㧦㨁㨚㨕㧛㧮㨕ޓ㧸㨛㨣
㧯㨔㨑㨏㨗ޓ㧠㧦㧭㨐㨖㨡㨟㨠㨙㨑㨚㨠
㧸㨛㨣㧣㧦㧮㨕㧰ޓ㧟㧞㧜ޓ㨂㧿㧰㧝
Set Paper
Finish printing
Change to PG_Low
Select Low or High
Select 7 to 12
Select Print1 or Print2 or Setup
If Head height is not Low
Print adjustment pattern
If media is not set
If the temperature of the pre-heater is below 47 ͠
and platen heater is below 42 C
* Pressing [Cancel] key stops control and start printing
㧮㨕㧰ޓ㧟㧞㧜ޓ㨂㧿㧰㧝㧦㧼㨞㨕㨚㨠㧞
㧯㨔㨍㨚㨓㨑ޓ㧴㨑㨍㨐ޓ㧳㨍㨜ޓ㧸㨛㨣
㧿㨑㨠ޓ㧼㨍㨜㨑㨞
㧭㨐㨖㨡㨟㨠㨙㨑㨚㨠㧼㨞㨕㨚㨠
㨃㨍㨞㨙㨕㨚㨓㨁㨜㧦㧼㨞㨑ޓޓޓ㧟㧤ࠑ㧯
Bi-Lo
320cps
VSD1
* ) (
'
& %
$ #
࡮࡮࡮
CW
CW
CCW
media feeding direction
Prints out the items excecuted.
Check the set value
of the joint point that is matched
BiD320 ޓ VSD1 ޓ : ޓ Bi-Lo/Hi 320cps VSD1
BiD320
ޓ
VSD3
ޓ
:
ޓ
Bi-Lo/Hi 320cps VSD3
BiD320 ޓ VSD4 ޓ : ޓ Bi-Lo/Hi 320cps VSD4
BiD ޓ VSD3 ޓ : ޓ Bi-Lo/Hi 400cps VSD3
BiD ޓ VSD4 ޓ : ޓ Bi-Lo/Hi 400cps VSD4
BiD ޓ VSD1 ޓ : ޓ Bi-Lo/Hi 400cps VSD1