MUTOH ValueJet VJ-1324, Maintenance Manual, Page: 324 / 439

5.7.5 Head Slant Check Menu P.5-38
5.7 Adjustment Menu VJ1324E-M-02
(1) Printing
「
Head slant
：
slant1
」
The printer prints out head slant check patterns in the following modes:
• 1 pass, Uni-D/Bi-D
• PF: 360 dpi, CR: 360 dpi
• According to the width of media,the right pattern is printed on three places or less.
T I P
When printing "Head slant: Slant1" adjustment pattern, the adjustment patterns for Head
slant (horizontal height) and Head slant (vertical) are also printed.
(1-a)Check Head slant (horizontal height).
Items to check are as follows.
A ： OK
B ： On a "Black" basis, shift Magenta upward.
C ： On a "Black" basis, shift Magenta downward.
1. When the print result has misalignment, perform machine adjustment.
"4.7.1 Head Alignment (Horizontal Height)" p.4-11
T I P
• From the media origin side, each path is printed in the combination shown below.
Nozzle lines A/C, A/E, A/G, B/D, B/F, B/H
• CW direction printing.
2. After machine adjustment, print the comfirmation pattern of Head slant again.
3. When Head slant is still misaligned, perform adjustment.
㧭㨐㨖㨡㨟㨠㨙㨑㨚㨠ޓ㧼㨞㨕㨚㨠
Finish printing
㧯㨔㨑㨏㨗ޓ㧠㧦㧭㨐㨖㨡㨟㨠㨙㨑㨚㨠
㧭㨐㨖ޓ㧡㧦㧴㨑㨍㨐㧿㨘㨍㨚㨠
㧴㨑㨍㨐㧿㨘㨍㨚㨠㧦㧿㨘㨍㨚㨠㧝
[Enter]
[Enter]
[Enter]
㧯㨔㨍㨚㨓㨑ޓ㧴㨑㨍㨐ޓ㧳㨍㨜ޓ㧸㨛㨣
Change to PG_LOW
20mm
Print direction
5mm
Check the alignment (horizontal height) with these joint points.
Look at this pattern
to check the alignment (vertical slant).
Refer to "Check vertical slant".
B A
C
&
Media
feeding
direction