Hitachi WJ200-001L, Instruction Manual

Page: 79 / 680

2

30
2. Select the digital operator for RUN Command
–
To RUN command causes the inverter to accelerate
the motor to the selected speed. The Run command
can arrive from various sources, including the
control terminals, the Run key on the keypad or the
network. In the figure to the right, notice the Run
Key Enable LED, just above the Run key. If the LED
is ON, the Run key is already selected as the source,
and you may skip this step. Note that the default
setting depends on the country.
If the Potentiometer Enable LED is OFF, follow these steps below (the table resumes
action from the end of the previous table).
Action Display Func./Parameter
(Starting point)

Speed command source setting
Press the

key

Run command source setting
Press the SET key 



Control terminal


Digital operator


ModBus network input
etc.
Press the

/

key to select 



Digital operator (selected)
Press the SET key to store

Stores parameter, returns to
“  ”
NOTE: After completing the steps above, the Run Key Enable LED will be ON. This
does not mean the motor is trying to run; it means that the RUN key is now enabled.
DO NOT press the RUN key at this time – complete the parameter setup first.
Run Key Enable LED
1
2
RUN
ESC
STOP/
RESET
SET

RUN
Hz
A
PWR
ALM
PRG