Hitachi WJ200-001L, Instruction Manual, Page: 669 / 680

Ver.3.1
−
− −
−
4
Addition of special monitor display and error
・
The set range of b145 has been expanded to support a new special monitor and error display.
In the expanded setting of b145, the signal states of EDM, GS1 and GS2 are monitored and special monitor
display content or error code is showed on keypad in accordance with table Ver.3.1-5.
・
b146 can adjust the delay time that specifies time to transit from state (4) to state(7) depicted in fig.
Ver.3.1-2. This parameter is valid only when b145=05. Once the state transits to state (7) in fig. Ver.3.1-2, it
is necessary to active (open) both GS1 and GS2 again (to state (2)), and then deactivate (close) both GS1 and
GS2 in order to return to normal operation (state (1)).
Table Ver.3.1-3
Func.
Func. Func.
Func.
Code Code Code Code
Name Name Name Name Description Description Description Description A A A A B B B B Initial data Initial data Initial data Initial data
Modbus
Modbus Modbus
Modbus register
register register
register
number number number number
Resolution Resolution Resolution Resolution
b1 b1 b1 b145 45 45 45
GS input mode select 00
00 00
00 ----05
05 05
05
Displays special monitor display
content and error specified in table
Ver.3.1-5. Please refer to table
Ver3.1-5.
00 1394h
-
b146
b146 b146
b146 Delay time of release
operation Valid only when b145 = 05,
range is 0.00 to 2.00 sec.
0.00 1395h 0.01 [sec]
<CAUTION>
・
This additional monitor function is just a supplementary display function. A whole system
must be designed and configured in accordance with the instructions in Appendix E.