Hitachi WJ200-001L, Instruction Manual

Page: 98 / 680

3

13
Run Command Source Setting
–
For parameter

, the following table provides a
further description of each option, and a reference to other page(s) for more information.
Code Run Command Source Refer to page(s)
…

Control terminal
– The [FW] or [RV] input terminals control
Run/Stop operation
4-16

Keypad Run key
– The Run and Stop keys provide control
2-23
 ModBus network input
– The network has a dedicated coil for
Run/Stop command and a coil for FW/RV
B-24

Option
– Select when an option card is connected and use the
frequency source from the option
(manual of each
option)

/

Override Sources
–
The inverter allows some sources to override the setting
for output frequency and Run command in

and

. This provides flexibility for
applications that occasionally need to use a different source, leaving the standard
settings in

/

.
The inverter has other control sources that can temporarily override the parameter

setting, forcing a different output frequency source. The following table lists all
frequency source setting methods and their relative priority (“1” is the highest priority).
Priority

Frequency Source Setting Method
Refer to page
…
1 [CF1] to [CF4] Multi-speed terminals 4-17
2 [OPE] Operator Control intelligent input 4-35
3 [F-TM] intelligent input 4-42
4 [AT] terminal 4-28
5

Frequency source setting
3-10
The inverter also has other control sources that can temporarily override the parameter

setting, forcing a different Run command source. The following table lists all Run
command setting methods and their relative priority (“1” is the highest priority).
Priority

Run Command Setting Method
Refer to page
…
1 [OPE] Operator Control intelligent input 4-35
2 [F-TM] intelligent input 4-42
3

Run command source setting
3-10