Hitachi WJ200-001L, Instruction Manual

Page: 493 / 680

Ver.2

64
“C” Function
Run
Mode
Edit
Defaults
Func.
Code
Name Description A B Initial data Units

[AM] terminal selection
(Analog voltage output
0...10V)
11 programmable functions:

 Output frequency


Output current

 Output torque

 Output voltage

 Input power

 Electronic thermal load ratio

 LAD frequency

 Heat sink temperature


Output torque (with code)


General output

 Option


07
[LAD]


Digital current monitor
reference value Current with digital current monitor
output at 1,440Hz
Range is 20%~200% of rated current
 
Rated
current
A

Output [11] active state Select logic conversion, two option codes:


normally open [NO]


normally closed [NC]


00 

Output [12] active state


00 

Alarm relay active state


01 

Output mode of low current
detection Two option codes:

 During acceleration, deceleration
and constant speed

 During constant speed only


01 

Low current detection level Set the level of low load detection, range
is 0.0 to 2.0*inverter rated current
 
INV rated
current
A

Output mode of overload
warning Two option codes:


During accel., decel. and constant
speed

 During constant speed only


01 

Overload warning level Sets the overload warning signal level
between 0% and 200% (from 0 to two time
the rated current of the inverter)
 
Rated
current
x 1.15
A

Overload warning level, 2
nd
motor
Sets the overload warning signal level
between 0% and 200% (from 0 to two time
the rated current of the inverter)
 
Rated
current
x 1.15
A

Frequency arrival setting for
acceleration Sets the frequency arrival setting
threshold for the output frequency during
acceleration,
range is 0.0 to 400.0 Hz


0.00 Hz

Frequency arrival setting for
deceleration Sets the frequency arrival setting
threshold for the output frequency during
deceleration,
range is 0.0 to 400.0 Hz


0.00 Hz

PID deviation level Sets the allowable PID loop error
magnitude (absolute value), SP-PV, range
is 0.0 to 100%


3.0 %

Frequency arrival setting 2
for acceleration Set range is 0.0 to 400.0 Hz


0.00 Hz

Frequency arrival setting 2
for deceleration Set range is 0.0 to 400.0 Hz


0.00 Hz

Pulse train input/output
scale conversion If EO terminal is configured as pulse
train input (C027=15), scale conversion is
set in C047.
Pulse-out = Pulse-in
 (C047)
Set range is 0.01 to 99.99
 
1.00


PID FBV output
high limit When the PV exceeds this value, the PID
loop turns OFF the PID second stage
output, range is 0.0 to 100%


100.0 %