Hitachi WJ200-001L, Instruction Manual, Page: 176 / 680

3

91
Output Function Summary Table
–
This table shows all functions for the logical outputs
(terminals [11], [12] and [AL]) at a glance. Detailed descriptions of these functions,
related parameters and settings, and example wiring diagrams are in “Using Intelligent
Output Terminals” in chapter 4.
Output Function Summary Table
Option
Code
Terminal
Symbol
Function Name Description

RUN Run Signal ON When the inverter is in Run Mode
OFF When the inverter is in Stop Mode

FA1 Frequency Arrival Type
1
–Constant Speed
ON When output to motor is at the set frequency
OFF When output to motor is OFF, or in any acceleration
or deceleration ramp
 FA2 Frequency Arrival Type
2
–Over frequency
ON When output to motor is at or above the set freq.,
even if in accel (

) or decel (

) ramps
OFF When output to motor is OFF, or at a level below the
set frequency
 OL Overload Advance
Notice Signal 1 ON When output current is more than the set threshold
(

) for the overload signal
OFF When output current is less than the set threshold
for the deviation signal

OD Output Deviation for PID
Control ON When PID error is more than the set threshold for
the deviation signal
OFF When PID error is less than the set threshold for the
deviation signal

AL Alarm Signal ON When an alarm signal has occurred and has not
been cleared
OFF When no alarm has occurred since the last cleaning
of alarm(s)
 FA3 Frequency Arrival Type
3
–Set frequency
ON When output to motor is at the set frequency, during
accel (

) and decel (

).
OFF When output to motor is OFF, or is not at a level of
the set frequency

OTQ Over/under Torque
Signal ON Estimated motor torque exceeds the specified level
OFF Estimated motor torque is lower than the specified
level

UV Undervoltage ON Inverter is in Undervoltage
OFF Inverter is not in Undervoltage

TRQ Torque Limited Signal ON Torque limit function is executing
OFF Torque limit function is not executing
 RNT Run Time Expired ON Total running time of the inverter exceeds the
specified value
OFF Total running time of the inverter does not exceed
the specified value

ONT Power ON time Expired ON Total power ON time of the inverter exceeds the
specified value
OFF Total power ON time of the inverter does not exceed
the specified value
 THM Thermal Warning ON
Accumulated thermal count exceeds the

set
value
OFF Accumulated thermal count does not exceed the

set value

BRK Brake Release Signal ON Output for brake release
OFF No action for brake
 BER Brake Error Signal ON Brake error has occurred
OFF Brake performance is normal

ZS Zero Hz Speed
Detection Signal ON Output frequency falls below the threshold specified
in
