Hitachi WJ200-001L, Instruction Manual

Page: 497 / 680

Ver.2

68
OFF Inverter is in Stop Mode, motor stops
 RV Reverse Run/Stop
ON Inverter is in Run Mode, motor runs reverse
OFF Inverter is in Stop Mode, motor stops
 CF1 *1
Multi-speed Select,
Bit 0 (LSB) ON Binary encoded speed select, Bit 0, logical 1
OFF Binary encoded speed select, Bit 0, logical 0
 CF2
Multi-speed Select,
Bit 1 ON Binary encoded speed select, Bit 1, logical 1
OFF Binary encoded speed select, Bit 1, logical 0

CF3
Multi-speed Select,
Bit 2 ON Binary encoded speed select, Bit 2, logical 1
OFF Binary encoded speed select, Bit 2, logical 0
 CF4
Multi-speed Select,
Bit 3 (MSB) ON Binary encoded speed select, Bit 3, logical 1
OFF Binary encoded speed select, Bit 3, logical 0
 JG Jogging
ON
Inverter is in Run Mode, output to motor runs at jog
parameter frequency
OFF Inverter is in Stop Mode
 DB External DC braking
ON DC braking will be applied during deceleration
OFF DC braking will not be applied
 SET
Set (select) 2nd Motor
Data
ON
The inverter uses 2nd motor parameters for generating
frequency output to motor
OFF
The inverter uses 1st (main) motor parameters for
generating frequency output to motor
 2CH
2-stage Acceleration
and Deceleration
ON
Frequency output uses 2nd-stage acceleration and
deceleration values
OFF
Frequency output uses standard acceleration and
deceleration values
 FRS Free-run Stop
ON
Causes output to turn OFF, allowing motor to free run
(coast) to stop
OFF
Output operates normally, so controlled deceleration stop
motor
 EXT External Trip
ON
When assigned input transitions OFF to ON, inverter
latches trip event and displays

OFF
No trip event for ON to OFF, any recorded trip events
remain in history until reset
 USP
Unattended Start
Protection
ON
On power up, the inverter will not resume a Run command
(mostly used in the US)
OFF
On power up, the inverter will resume a Run command that
was active before power loss

CS
Commercial power
source switchover
ON Motor can be driven by commercial power
OFF Motor is driven via the inverter
 SFT Software Lock
ON
The keypad and remote programming devices are prevented
from changing parameters
OFF The parameters may be edited and stored
 AT
Analog Input
Voltage/Current Select ON
Refer to “Analog Input Settings” on page 3-13.
OFF
 RS Reset Inverter
ON
The trip condition is reset, the motor output is turned OFF,
and power up reset is asserted
OFF Normal power-ON operation
 PTC
PTC thermistor
Thermal Protection
(C005 only)
ANLG
When a thermistor is connected to terminal [5] and [L], the
inverter checks for over-temperature and will cause trip
event and turn OFF output to motor
OPEN
A disconnect of the thermistor causes a trip event, and the
inverter turns OFF the motor
Input Function Summary Table
Option
Code
Terminal
Symbol
Function Name Description
 STA
Start
(3-wire interface) ON Starts the motor rotation
OFF No change to present motor status
 STP
Stop
(3-wire interface) ON Stops the motor rotation
OFF No change to present motor status
 F/R
FWD, REV
(3-wire interface)
ON
Selects the direction of motor rotation: ON = FWD. While the
motor is rotating, a change of F/R will start a deceleration,
followed by a change in direction