Hitachi WJ200-001L, Instruction Manual, Page: 433 / 680

Ver.2

4
14.1.3 PM mode switching
It changes to the PM mode by setting the initialization trigger (b180) to 01 after setting the inverter mode
selection (b171) to 03, and initialization is executed.
■
When using this mode, observe the following precautions.
①
hen 01 is set on the initialization trigger (b180), and SET key is pressed, initialization starts immediately
and there is not any way to restore the previous parameter setting.
②
All data will be initialized regardless the setting of b094. b094
③
The settings of "P100" to "P131", running-time data, and power-on time data cannot be cleared.
④
When display is restricted by the function code display restriction function (b037) or software is locked by
the software lock function (b031), you cannot initialize because the function codes of initialization are
no-display. If you forget password that restrict setting (b031) and (b037), you cannot cancel it. (So you
cannot initialize when software lock is active, you note that the setting password. (See section 7.6.11 the
password function.))
Item Function code Data or range of data Description
Inverter mode selection b171
00 No
03 PM mode
Initialization trigger b180
00 No action
01 Initialize