Hitachi WJ200-001L, Instruction Manual

Page: 225 / 680

4

18
While using the multi-speed capability, you can monitor the present frequency with
monitor function

during each segment of a multi-speed operation.
NOTE: When using the Multi-speed Select settings CF1 to CF4, do not display
parameter F001 or change the value of

while the inverter is in Run Mode (motor
running). If it is necessary to check the value of

during Run Mode, please monitor

instead of

.
There are two ways to program the speeds into the registers

to

:
1. Standard keypad programming:
a. Select each parameter

to

.
b. Press the SET key to view the parameter value.
c. Use the

and

keys to edit the value.
d. Use the SET key to save the data to memory.
2. Programming using the CF switches. Set the speed by following these steps:
a. Turn the Run command OFF (Stop Mode).
b. Turn inputs ON to select desired Multi-speed. Display the value of

on the
digital operator.
c. Set the desired output frequency by pressing the

and

keys.
d. Press the SET key once to store the set frequency. When this occurs,

indicates the output frequency of Multi-speed n.
e. Press the SET key once to confirm that the indication is the same as the set
frequency.
f. Repeat operations in 2. a) to 2. e) to set the frequency of other Multi-speeds. It
can be set also by parameters

to

in the first procedure 1. a) to 1. d).