Hitachi WJ200-001L, Instruction Manual, Page: 182 / 680

3

97
“C” Function Run
Mode
Edit
Defaults
Func.
Code
Name Description Initial data Units

PID FBV output
low limit When the PV goes below this
value, the PID loop turns ON the
PID second stage output, range is
0.0 to 100%

0.0 %

Over-torque/under-torque
selection Two option codes:

 Over-torque

 Under-torque

00 

Over/under-torque level
(Forward powering mode) Set range is 0 to 200%

100. %

Over/under-torque level
(Reverse regen. mode) Set range is 0 to 200%

100. %

Over/under-torque level
(Reverse powering mode) Set range is 0 to 200%

100. %

Over/under-torque level
(Forward regen. mode) Set range is 0 to 200%

100. %

Signal output mode of
Over/under-torque Two option codes:

 During accel., decel. and
constant speed


During constant speed only

01 

Electronic thermal
warning level Set range is 0 to 100%
Setting 0 means disabled.

90 %

Zero speed detection level Set range is 0.0 to 100.0Hz

0.00 Hz

Heat sink overheat
warning Set range is 0 to 110  C

100.  C

Overload warning level 2 Sets the overload warning signal
level between 0% and 200% (from
0 to two time the rated current of
the inverter)

Rated current
x 1.15
A