Toshiba GR 200 Series, Instruction Manual

Page: 989 / 1563

6F2S1915 (0.46)
GRZ200 (Soft 031 & 032)
- 968 -
BO1_SOURCE 200B01 310200E11D
Function key logic for F1
(Function ID: 240001)
PLC connection point in BO1
≥1
& [ BO1_CPL ]
Off
On
&
DRIVER BO1
Signal designated by
setting [ Input signal 1 ]
[ Input signal 2 ]
[ Input signal 3 ]
[ Input signal 4 ]
[ Input signal 5 ]
[ Input signal 6 ]
[ Input signal 7 ]
[ Input signal 8 ]
Signal to the
device
≥1
“BO1”
(200B01 _ 8002001112)
“BO1-RB”
(200B01 _ 8002001113)
BO1 circuit at IO_SLOT1 (Function ID: 200B01)
Terminal and
wire
To contact health
check
F1
Pressing the F1 key
“F1 SIGNAL”
(240001 _ 3100001737)
Setting Data ID
“F1
SIGNAL
” for the
[ Input signal 1 ]
Setting Data ID
“BO1_SOURCE”
for the [ Signal ]
†
[ Logic ]
Instant
&
Toggle
“FUNC-KEY1”
(240001 _ 3100001730)
&
Figure 5.6-3 F1 key connected with the BO1
‡
‡Note: The BO1 circuit is used just for an explanation; it is discussed in Chapter
Technical description: Binary IO module.
†Note: When the user wishes to inject the signal at the PLC connection point of the “BO1-
SOURCE (
200B01 31200E11D
at the IO#1 slot)”, the user should set the BO1-
SOURCE (
200B01 31200E11D
) for the setting [
Signal
] of the F1 key. Then, set
Off
for the scheme switch [
BO1_CPL
]
The user can select either
Toggle
or
Instant
modes for the signal generation using scheme
switch [
LOGIC
], as shown in Table 5.6-4. Thus, the user can substitute “F1-SIGNAL (
240001
310001737
)” for the “FUNC-KEY1 SIGNAL (
240001 310001730
)”, provided the
Toggle
mode
is preferred. In the Table 5.6-7 the other FUNC-KEY2 to FUNC-KEY7 are shown.
Table 5.6-4 Signal mode selection using setting [LOGIC]
Setting Generated signal corresponding to pressing the function key
Toggle
Pressing Key
Binary signal
Instant
Pressing Key
Binary signal
(iii)
Lighting LEDs on F1 to F7
Figure 5.6-4 shows the F1 to F7 LED logics. Programing to light the LEDs (F1 to F7) is the
same as the programing of the LED indicators (#3 to #26) (for the programming, see section
5.6.2). As a default, e.g., the “FUNC-KEY1 (
240001 310001730
)” is set for the setting [
Input
signal 1
] of the F1 LED logic. The LED-F2 to F7 points are listed in Table 5.6-8.