Toshiba GR 200 Series, Instruction Manual

Page: 472 / 1563

6F2S1915 (0.46)
GRZ200 (Soft 031 & 032)
- 451 -
ASEQ
User’s PLC
logic
SPOS
PLC connection point
DPOS
User’s PLC
logic
PLC monitoring point
Figure 3.5-2 Example of user-preferred control scheme using PLC user logic
Note: The user-preferred control scheme implemented by users can only be operated in
the DIR mode.
3.5.4
Signal for Local/Remote control
Note: The following references are used in the column “M/O” in Table 3.5-3 and Table
3.5-4:
“O” means the signal is optional.
“M” means the user should map/set/configure the signal; otherwise, the user
may experience an operational failure if the default settings are used.
“N/A” means that the user cannot change the state of the signal.
Table 3.5-3 PLC connection point (Input point for LOCRMT)
Signal Number Signal Name Description M/O
240001 31000A1735 L/R CHG [L/R] key “push” N/A
530001 800901EDE0 LRSW01_PLC_SGN01 Disable condition by PLC O
530001 800901EDE1 LRSW01_PLC_SGN02 User configurable condition by PLC O
Table 3.5-4 Mapping points for LOCRMT
Signal Number Signal Name Description M/O
530001 3009011008 LRSW01_LR_ORCAT Mapping data for “originator” in IEC61850 N/A
530001 6A09011009 LRSW01_LR_ORIDENT Mapping data for “originator” in IEC61850 N/A
Table 3.5-5 PLC monitoring point (LOCRMT)
Signal Number Signal Name Description
530001 3109001001 LRSW01_LR_ST Local(T) / Remote(F) status (single bit expression)
530001 3009011001 LRSW01_LR_ST_RMT Local(0x40) / Remote(0x80) status (double bit expression)