Toshiba GR 200 Series, Instruction Manual

Page: 656 / 1563

6F2S1915 (0.46)
GRZ200 (Soft 031 & 032)
- 635 -
Table 4.3-19 shows the required mapping signals in SOFTSW1 function to the IEC 61850
communications. Figure 4.3-25 shows how to map a signal.
Table 4.3-19 Mapping signals for SPCSO object.
Object_reference Attribute Type FC Signal Number Signal Name
Ctrl/GGIO701$SPCSO$origin orCat orCategory ST 522001 310A041008 S4301_ORCAT
Ctrl/GGIO701$SPCSO$origin orIdent Octet64 ST 522001 6A0A041009 S4301_ORIDENT
Ctrl/GGIO701$SPCSO stVal INT32 ST 522001 000A041001 S4301_STATE
Ctrl/GGIO701$SPCSO q Quality ST 522001 310A041005 S4301_QUALITY
Ctrl/GGIO701$SPCSO t Timestamp ST 522001 900A041006 S4301_TIME
Ctrl/GGIO701$SPCSO stSeld BOOLEAN ST 522001 000A041D90 S4301_STSELD
Note: “Status (ST)” is defined in the function constraint (FC) of the IEC 61850 standard.
Figure 4.3-25 orCat attribute mapped into SPCSO object of GGIO701
(iii)
Mapping input data
The SOFTSW1 function can receive three commands “select, operate, and cancel. Thus, the
user should map the input-point “S4301_CONTROL_REQ”. Table 4.3-20 shows the input-point
“S4301_CONTROL_REQ” and the Object reference
“Ctrl/GGIO701$SPCSO”; the user should map
the Object reference having
attributes CO and CF in FC† to the input-point. Figure 4.3-26 shows
how to map a signal.
†Note: The attribute is defined in the IEC 61850 standard; “CO” stands for “Control”
and “CF” stands for “Configuration” in the functional constraint (FC).