KLIC-N-KUT KNK Force, User Manual

Page: 295 / 401

295
•
Also, note that the material can be located anywhere on the cutting mat because you are setting the origin
on the material itself. It is usually advisable to set that origin just a little way inside the corner of the material
so that you do not inadvertently cut off the edge.
10.07.3 WYSIWYG
•
This is the mode recommended when you need to cut shapes in a very specific location relative to the
onscreen
Cutting Mat or when you are utilizing multiple tools in applications such as draw and cut or
emboss and cut.
•
Shapes are cut based on where they are located on the virtual Cutting Mat . There are two methods used:

Cutting Mat Method : The virtual Cutting Mat dimensions should match those of the grid on the actual
cutting mat. The origin is set in the exact lower right corner of the mat’s grid. The material needs to be
placed on the cutting mat so that it covers the area where the shapes will be cut.

Material Method: The virtual Cutting Mat dimensions should match those of the material being placed
on the actual cutting mat. The origin is set in the lower right corner of the material regardless of where
the material is placed on the mat. In the example later on,
the material is assumed to be letter size (8.5”
x 11”).
•
In the following diagrams the purple and green arrows are used to indicate the equivalent distances
between the shapes and the origin on the virtual
Cutting Mat and on the actual mat.

WYSIWYG
– Portrait – Cutting Mat Method
Landscape mode Portrait mode
Origin set here
Origin set here