344
(3) You can modify the settings for the reg mark size, line thickness and offset from the image to be cut. The
latter one,
Mark offset
, should be changed from the current setting to 0.03 cm so that the reg marks will be
as close as possible to the printed imag
e. This isn’t an absolute requirement but it does allow more of the
page to be used for your project. Once the settings have been changed, click on
Save
at the bottom of that
window.
(4) Under
Tool
, select
1(left)
and enter the following settings. Use whatever
Cutting Depth
works best for
cutting your printer paper.
Important:
Keep the
Up Speed
and
Cut Speed
low, as shown:
(5) Load the blade holder onto the left side using
Replace Tool.
Then click on
Print+Cut.
(6) The following
Print and Cut
window will open.
Select
Blade
Select
1(left)
Set
Cut Speed
to 20
Set
Up Speed
to 20
After blade holder is
installed, click here.
Instructions for
future reference
These buttons or the
arrow keys on your
keyboard will be clicked to
move the head
To open print
window click here.
The camera image of the
registration marks will be
displayed here
Calibration settings will be
entered by clicking here
Click here
Reg mark
settings
Summary of Contents for KNK Force
Page 306: ...306...
