10
1. Introduction
1
1.01 Please Read!
Thank you for purchasing a KNK Force!
Please read all of this section before using your new Force with Sure
Cuts A Lot (SCAL).
•
Because the Force must first be set up to communicate with C3 (the program residing on the computer
inside of the Force), please read all of the first two chapters of the
KNK Force with C3 User Manual
(henceforth referred to as the
C3 User Manual
) here:
http://www.iloveknk.com/support/knk-force-support-page
•
Write down the IP Address used to access C3 on your Force. You will need to enter this same IP Address
into the Force
Cut Settings
window in SCAL.
•
It is also important to install updates to C3 as some of them will contain firmware changes that can impact
how the Force works with SCAL. Instructions for updating C3 are contained in
Section 4.03
of the
C3 User
Manual
.
•
Certain sections of the
C3 User Manual
have been repeated in this user manual for convenience or because
they are important reminders. Feel free to skip certain sections:
If you have thoroughly read
Chapters 1 and 2
in the
C3 User Manual
, you can move on to
Section 1.06
in this chapter. Please read that section and
Chapter 2
before attempting to use the blade holder in your
Force.
If you have already been using SCAL with your KNK Force, you can use this user manual as a
reference book.
1.02 Safety and Warnings
Please be aware of the following safety guidelines when working with the KNK Force:
•
Pinch Points:
Keep hands, long hair, loose clothing, jewelry, etc. away from the moving parts.
•
Risk to Children and Pets:
Please supervise children around the Force, when it is in use. In particular, the
rotary device can pose a danger to unsupervised children and pets.
•
Eye Protection:
When operating the rotary device, eye protection, such as safety glasses, is recommended.
•
Rotary Tool Instructions:
Please read
Chapter 13
before using the optional rotary tool.
•
Movement and Touching:
Do not move the KNK Force or touch any circuitry while it is plugged in.
•
Additionally:
DO NOT touch or jam the plotter’s track while it is operating. If the cutter is damaged, it is the owner’s
responsibility.
DO NOT shake the cutter while it is operating.
DO NOT cut any materials that have staples or other embellishments attached.
DO NOT touch the cutter with a magnet. It is safe, however, to cut magnetic materials, such as those
used on refrigerators and car exteriors.
DO NOT allow small items to fall into the cutter.
1
© 2015 - 2019 Accugraphic Sales, Inc., All Rights Reserved
Summary of Contents for KNK Force
Page 306: ...306...
