331
•
Shapes can be located anywhere on the virtual
Cutting Mat
. The shapes will be moved and aligned to cut
with the origin you set on the material. As mentioned earlier, the origin is set using the position of the
blade
tip
(or other tool installed on the left side). It is typically set just inside the lower right corner of the material
being cut.
•
When more than one shape will be cut, the shape closest to the origin will be cut at the origin and any other
shapes will be cut the distance and direction from that shape as positioned on the screen. The following
figures show examples of where images will cut. Use the arrow on the
Cutting Mat
as a guide to the
direction to insert the actual mat or material into your cutter.
Origin Point
– Portrait Mode
Origin Point
– Landscape Mode
•
Note that the alignment is based on the bounding box around the shapes:
Location of shapes
in SCAL
Where shapes will draw or cut on the material
Feed
the mat this direction into the
cutter
Origin set here
Shapes are cut to
align with the
origin you set on
the
cutter .
Indicates
Portrait
mode
Feed the mat this direction into the
cutter
Indicates
Landscape
mode
Location of shapes
in SCAL
Where shapes will draw or cut on the material
Origin set here
Shapes are cut to
align with the
origin you set on
the
cutter
Summary of Contents for KNK Force
Page 306: ...306...
