358
12.02.4 Adjusting the Tool Offset Values
•
Click on
Cut
and the Force will perform the dual head procedure.
•
For a perfect calibration, the two squares should be perfectly aligned. To adjust the X and Y tool offsets,
measure the left/right difference and the up/down difference:
•
Go to
Cutter>Cutter Settings
. Use the following guidelines to change the values of
Tool offset X
and
Tool
offset Y:
If right tool is drawing too far left, increase
X
OR If right tool is drawing too far right, decrease
X
If right tool is drawing too high, increase
Y
OR If right tool is drawing too low, decrease
Y
Also, remember that:
Increasing a negative number makes it less negative (e.g. from -1.5 to -1.4)
Decreasing a negative number makes it more negative (e.g. from -0.8 to -0.9)
•
Repeat the calibration test to make sure the two tools are in alignment. You might need to repeat once or
twice more, until the results are perfect.
Change to
Pen
Enter other settings based on
the material you are using.
Select the
right side
Uncheck this box, unless
you want cutter to pause
between tools.
Verify that
Draw draw
lines
is selected
Tool offset X
Tool offset Y
Summary of Contents for KNK Force
Page 306: ...306...
