IBM @Server pSeries 630 6C4, Service Manual

Page: 472 / 651

1 System Unit 5 PCI adapter face plate (dotted lines)
2 Adapter Retainer Assembly 6 Adapter Retainer Assembly (in the unlocked
position)
3 Adapter Retainer Assembly (retainer seat
down and the retainer clip in the locked
position) 7 PCI Adapter
4 Adapter Retainer Assembly (retainer seat
down and the retainer clip in the unlocked
position)
23. Carefully grasp the adapter by the edges, and pull it straight out from the PCI riser card.
24. If you are not installing another adapter in this slot, place an expansion slot cover in the adapter slot
opening.
25. Lower the plastic retainer seat over the PCI adapter faceplate.
26. Rotate the locking latch clockwise until it clicks into the locked position.
27. Continue to follow the screen instructions until you receive a message that the adapter removal is
successful. Successful removal is indicated by the
OK
message displayed next to the Command field
at the top of the screen.
28. If you do not have other adapters to remove, continue with the next step.
OR
If you have other adapters to remove, press the F3 key to return to the PCI Hot-Plug Manager menu
and then return to step 14 on page 450.
29. Press F10 to exit the Hot-Plug Manager.
30. If you have added, removed, or replaced any adapters, run the
diag -a command. If the system
responds with a menu or prompt, follow the instructions to complete the device configuration.
31. If you have other options to install, refer to the “Procedure List” on page 422. If you do not have other
options to install, continue on to the next step.
32. Replace the service access cover as described in “Service Access Cover Replacement (Model 6C4)”
on page 431 or “Service Access Cover Replacement (Model 6E4)” on page 437.
33. On a Model 6C4, push the system drawer back into the operating position as described in “Returning
the Model 6C4 to the Operating Position” on page 430.
34. Connect the adapter cables.
35. On a Model 6C4, route the cables through the cable-management arm.
36. On a Model 6C4, close the rack doors.
On a Model 6E4, close the bezel door.
452
Eserver
pSeries 630 Model 6C4 and Model 6E4 Service Guide