IBM @Server pSeries 630 6C4, Service Manual

Page: 462 / 651

Bezels
Before performing the following procedures, read the “Safety Notices” on page xi.
Front Bezel Removal (Model 6C4)
To remove the bezel, do the following:
1. Open the front rack door and place the system into the service position as described in “Placing the
Model 6C4 into the Service Position” on page 429.
2. Press in on both bezel-release tabs at the same time. See the following illustration for bezel-release
tab locations.
3. Gently pull the bezel away from the system.
4. Put the bezel in a safe place.
1 Rack Door 3 Bezel-Release Tab (Located on each side of bezel)
2 Bezel 4 19-Inch Rack
Front Bezel Replacement (Model 6C4)
To replace the front bezel, do the following:
1. Open the front rack door and place the system into the service position as described in “Placing the
Model 6C4 into the Service Position” on page 429.
2. Seat the two tabs located on the bottom edge of the bezel into their mating slots located on the bottom
edge of the system.
3. Pivot the bezel up, aligning the release tabs to the mating slots located on the front of the system.
4. Gently push the tabs into the slots until the bezel seats against the front of the system.
5. Push the system drawer back into the operating position as described in “Returning the Model 6C4 to
the Operating Position” on page 430.
6. Close the rack door.
442
Eserver
pSeries 630 Model 6C4 and Model 6E4 Service Guide