IBM @Server pSeries 630 6C4, Service Manual

Page: 452 / 651

Top Cap Removal (Model 6E4)
To remove the top cap, do the following:
1. Remove the bezel door as described in “Bezel Door Removal” on page 441.
2. Remove the front bezel as described in “Front Bezel Removal (Model 6E4)” on page 443.
3. From the front of the top cap, grasp the two lower side edges and pry out to release the lower front
tabs.
4. Pivot the cover up to release the two back tabs.
5. Lift the top cap up and off the system.
1 Top Cap 4 Bezel Door
2 Top Cap Rear Locking Tabs 5 Bezel
3 Top Cap Front Locking Tabs 6 Model 6E4
Top Cap Replacement (Model 6E4)
To replace the top cap, do the following:
1. Align, and then insert the two tabs located on the back-bottom edge of the top cap with the two mating
slots located on the top cover.
2. Rotate the cover down, snapping the two lower front tabs into place on the operator panel bracket.
3. Replace the front bezel as described in “Front Bezel Replacement (Model 6E4)” on page 443.
4. Replace the bezel door as described in “Bezel Door Replacement” on page 441.
432
Eserver
pSeries 630 Model 6C4 and Model 6E4 Service Guide