IBM @Server pSeries 630 6C4, Service Manual

Page: 246 / 651

Firmware Error Codes
Attention: If you replace FRUs or perform an action and the problem is still not corrected, go to “MAP
1548: Processor Subsystem Problem Isolation” on page 139 unless otherwise indicated in the tables.
If you replace FRUs and the problem is corrected, go to
″
MAP 0410: Repair Checkout
″
in the RS/6000
Eserver
pSeries Diagnostic Information for Multiple Bus Systems .
Table 4. Firmware Error Codes.
Error Code Description Action/
Possible Failing FRU
20A8 0000 Insufficient information to boot. Verify the IP address.
20A8 0001 The client IP address is already in use by some
other network device.
Change IP address.
20A8 0002 Cannot get gateway IP address. Refer to 168 using code E174 .
20A8 0003 Cannot get system hardware address. Refer to 168 using code E174 .
20A8 0004 Bootup failed. Refer to 168 using code E175 .
20A8 0005 File transmission (TFTP) failed. Check network connection, try again.
20A8 0006 Boot image too large Contact your next level of support for
assistance.
20D0 0001 I/O subsystem has changed locations This is an informational message.
The I/O subsystem at the location code
associated with this message was found at
another location code during a prior boot of the
system.
If an I/O subsystem has not been moved, do
the following:
1. Boot the system and match the I/O
subsystem location codes reported by the
operating system to the subsystems
attached to the CEC. Check the SPCN and
RIO cabling to the I/O subsystems. If an
cabling problem is found, correct it.
2. If no cabling problem is found, call your
next level of support.
20D0 000F Self-test failed on a device, no error and/or
location code information available.
Refer to “Mapping AIX and Physical Location
Codes” on page 28 to see if a location code is
available for the device the error was reported
against.
1. Replace device indicated by the location
code (if available).
2. Go to “MAP 1542: I/O Problem Isolation” on
page 127
20D0 0010 Self-test failed on a device, cannot locate
package
Contact your service support representative for
assistance.
20D0 0011 Firmware RTAS attempt to allocate memory
failed.
Contact your next level of support for
assistance.
20D0 0800 Firmware update failure Retry the flash update.
20D0 0801 System firmware update failure Retry the firmware update.
20D0 0997 Operating system terminated with error string Call service support.
226
Eserver
pSeries 630 Model 6C4 and Model 6E4 Service Guide