IBM @Server pSeries 630 6C4, Service Manual

Page: 408 / 651

Call-in and ring indicate power-on cannot be enabled at the same time. If ring-indicate power-on is already
enabled and you try to enable call-in, a message prompts you for confirmation. Refer to the message
displayed on the screen.
Serial Port Speed Setup Menu
This menu allows you to set serial port speed to enhance terminal performance or to accommodate
modem capabilities.
Serial Port Speed Setup Menu
1. Serial Port 1 Speed:
Currently 9600
2. Serial Port 2 Speed:
Currently 9600
98. Return to Previous Menu
0>
A serial port speed of 9600 baud or higher is recommended. The following are valid serial port speeds:
50 600 4800
75 1200 7200
110 1800 9600
134 2000 19200
150 2400 38000
300 3600 57600
115200
Telephone Number Setup Menu
Note: These menus are available, however, the function of calling out to report a system failure is
normally handled by the Service Focal Point application running on the HMC.
Use this menu to set or change the telephone numbers for reporting a system failure.
Telephone Number Setup Menu
1. Service Center Telephone Number:
Currently Unassigned
2. Customer Administration Center Telephone Number:
Currently Unassigned
3. Digital Pager Telephone Number:
Currently Unassigned
4. Customer Voice Telephone Number:
Currently Unassigned
5. Customer System Telephone Number:
Currently Unassigned
98. Return to Previous Menu
0>
388
Eserver
pSeries 630 Model 6C4 and Model 6E4 Service Guide