IBM @Server pSeries 630 6C4, Service Manual

Page: 461 / 651

Bezel Door (Model 6E4)
The following procedure covers removal and replacement of the bezel door.
Bezel Door Removal
Refer to the following illustration while you perform the steps in this procedure.
To remove the bezel door, do the following:
1. Open the bezel door by grasping the bezel door handle. Pull the bezel door out and away from the
system.
2. Press down on the top back edge of the door.
3. Gently swivel the top back edge of the door forward, out past the top of the system.
4. Lift the door up to release it from the lower retaining post.
1 Model 6E4 4 Bezel Door
2 System Handle Assembly 5 Bezel Door Handle
3 Bezel Door Top Retaining Post 6 Bezel Door Lock Tab
7 Bezel Door Lower Retaining Post
Bezel Door Replacement
To replace the bezel door, do the following:
1. Place the bezel door on the lower retaining post. See the preceding illustration.
2. Rotate the bezel door toward the top of the system.
3. Press down on the back edge of the bezel door, and seat the top post into its mating hole.
Note: The mating hole for the top post is located on the bottom side of the system handle assembly.
4. Close the bezel door.
Chapter 9. Removal and Replacement Procedures
441