IBM @Server pSeries 630 6C4, Service Manual

Page: 406 / 651

Call-In/Call-Out Setup Menu
Note: The information in this section regarding the configuring of serial ports, and modems attached to
those serial ports, applies only to the serial ports (S1 and S2) on the CEC backplane (location
U0.1-P1). These serial ports are normally used for call-in and call-out.
Call-out is disabled in partitioned systems. The call-out function is normally handled by the Service
Focal Point application running on the HMC.
None of these menus are applicable to the serial ports, or modems attached to those serial ports,
on the HMC.
CALL-IN/CALL-OUT SETUP MENU
1. Modem Configuration Menu
2. Serial Port Selection Menu
3. Serial Port Speed Setup Menu
4. Telephone Number Setup Menu
5. Call-Out Policy Setup Menu
6. Customer Account Setup Menu
7. Call-Out Test
NOT supported in LPAR mode
98. Return to Previous Menu
99. Exit from Menus
0>
v
Modem Configuration Menu , see “Modem Configuration Menu” on page 387.
v
Serial Port Selection Menu , see “Serial Port Selection Menu” on page 387.
v
Serial Port Speed Setup Menu , see “Serial Port Speed Setup Menu” on page 388.
v Telephone Number Setup Menu , see “Telephone Number Setup Menu” on page 388.
v
Call-Out Policy Setup Menu , see “Call-Out Policy Setup Menu” on page 389.
v Customer Account Setup Menu , see “Customer Account Setup Menu” on page 390.
v
Call-Out Test tests the configuration after the modem is installed and configured correctly (disabled in
partitioned systems).
386
Eserver
pSeries 630 Model 6C4 and Model 6E4 Service Guide