Beckman Coulter UniCel DxC 600, Instructions For Use Manual

Page: 449 / 498

A13
9
14
AF
12-
1
1
T
roubl
es
hoo
tin
g
C
a
libr
a
ti
on and
Res
u
lt
E
rr
o
rs
Co
m
m
o
n
Er
ro
r Me
ss
a
g
e
s a
n
d C
o
rr
e
ct
ive
A
ct
io
n
s
12
0x02620019
2
CC Sample Delivery
Subsystem Motion
Error, Pausing CAU: CC Sample Delivery
Subsystem Motion Error,
Pausing
Message ID:
0x02620019
Subsystem: ccScheduler
This occurs after two motion errors on
the Sample Delivery Subsystem. Level
Sense errors will not trigger this error.
The system goes into
Pausing and then
Stopped state.
• Raise canopy and check for obvious obstruction
of the sample probe or syringe.
• Press the STOP button and Home the system.
While system is homing, observe motion of the
CC sample syringe and CC Sample probe. The
probe and syringe should complete their
operations in a smooth manner.
•
If the error continues, check the event log to
determine if the syringe or probe is responsible
for the error.
•
If the CC sample probe is responsible, perform
the appropriate vertical or horizontal alignment.
Refer to Step 3 in the
Install the New Probe
procedure.
• If the Syringe is responsible, check for proper
seating of syringe assembly.
•
Contact Beckman Coulter Support Center for
additional information.
0x0262001A
4
CC Sample Probe
Obstruction
Sample ID:
Rack ID:
Rack Position:
This occurs on first
attempt
CAU: CC Sample Probe
Obstruction
Message ID: 0x0262001A
Subsystem: RASched
Sample ID:
Rack ID:
Rack Position:
Sample Error Count:
Probe Error Count:
Cycle Number:
This error occurs when the CC sample
probe ODC (Obstruction Detection &
Correction) indicates that the probe is
obstructed during sample aspiration. • No operator action is necessary.
• The system will attempt a second aspiration
from this sample.
Table 12.10 Error Messages and Corrective Actions (Continued)
ID
Class #
Pop-up Event Log Description Corrective Action