Beckman Coulter UniCel DxC 600, Instructions For Use Manual

Page: 381 / 498

A13914AF
10-17
System Status and Commands
Enable/Disable Modules
10

All programming for Disabled modules is aborted. Modules or subsystems in the Disable mode
will not run, prime, or perform desired maintenance/diagnostic procedures.
When the MC module is enabled, the related reagent is primed 4 times. When the CC subsystem is
enabled, the system runs startup primes.
With an error, for example Reagent too full , the DxC automatically disables a module or subsystem.
The Rgts/Cal status screen changes to
Disable
(refer to CHAPTER 4,
Reagent Load/Calibration
for
additional information).
IMPORTANT
When an MC Module or CC subsystem is enabled, the calibration status will not be lost. Check
the calibration status screen prior to running the system.
IMPORTANT
When a module is Enabled, the system will go to Standby as it prepares for a prime. The system
will not accept work requests at this time. Reagents should be reloaded when a module is Enabled to
ensure that fresh reagents are used for subsequent testing.
Disable Modules
1
Select
Instr Cmd
from the menu bar.
2
Select
7 Enable/Disable Modules
.
3
Select the desired module button to disable.
4
Select
OK
to Disable the desired modules.
5
Select
OK
to confirm Modules shown in the message box.
OR
Select
Cancel
to exit without saving changes.
Enable Modules
IMPORTANT
After enabling a chemistry or a module, run controls to verify proper operation.
If a reagent is loaded while the module is disabled, prime the module eight times after the module has
been enabled.
Starting from a Stopped state, a module is not enabled until the system is homed and goes to Standby .
1
Select
Instr Cmd
from the menu bar.