16.6.2.4. Enabling a Generator
A Generator is enabled by writing a '1' to the Generator Enable bit in the Generator Control register
(GENCTRLn.GENEN=1).
16.6.2.5. Disabling a Generator
A Generator is disabled by writing a '0' to GENCTRLn.GENEN. When GENCTRLn.GENEN=0, the
GCLK_GEN[n] clock is disabled and gated.
16.6.2.6. Selecting a Clock Source for the Generator
Each Generator can individually select a clock source by setting the Source Select bit group in the
Generator Control register (GENCTRLn.SRC).
Changing from one clock source, for example A, to another clock source, B, can be done on the fly: If
clock source B is not ready, the Generator will continue using clock source A. As soon as source B is
ready, the Generator will switch to it. During the switching operation, the Generator maintains clock
requests to both clock sources A and B, and will release source A as soon as the switch is done. The
according bit in SYNCBUSY register (SYNCBUSY.GENCTRLn) will remain '1' until the switch operation is
completed.
The available clock sources are device dependent (usually the oscillators, RC oscillators, DPLL, and
DFLL). Only Generator 1 can be used as a common source for all other generators.
16.6.2.7. Changing the Clock Frequency
The selected source for a Generator can be divided by writing a division value in the Division Factor bit
field of the Generator Control register (GENCTRLn.DIV). How the actual division factor is calculated is
depending on the Divide Selection bit (GENCTRLn.DIVSEL).
If GENCTRLn.DIVSEL=0 and GENCTRLn.DIV is either 0 or 1, the output clock will be undivided.
Note:
The number of DIV bits for each Generator is device dependent.
16.6.2.8. Duty Cycle
When dividing a clock with an odd division factor, the duty-cycle will not be 50/50. Setting the Improve
Duty Cycle bit of the Generator Control register (GENCTRLn.IDC) will result in a 50/50 duty cycle.
16.6.2.9. External Clock
The output clock (GCLK_GEN) of each Generator can be sent to I/O pins (GCLK_IO).
If the Output Enable bit in the Generator Control register is set (GENCTRLn.OE = 1) and the generator is
enabled (GENCTRLn.GENEN=1), the Generator requests its clock source and the GCLK_GEN clock is
output to an I/O pin.
If GENCTRLn.OE is 0, the according I/O pin is set to an Output Off Value, which is selected by
GENCTRLn.OOV: If GENCTRLn.OOV is '0', the output clock will be low when turned off. If this bit is '1',
the output clock will be high when turned off.
In Standby mode, if the clock is output (GENCTRLn.OE=1), the clock on the I/O pin is frozen to the OOV
value if the Run In Standby bit of the Generic Control register (GENCTRLn.RUNSTDBY) is zero. If
GENCTRLn.RUNSTDBY is '1', the GCLKGEN clock is kept running and output to the I/O pin.
Atmel SAM L22G / L22J / L22N [DATASHEET]
Atmel-42402E-SAM L22G / L22J / L22N_Datasheet_Complete-07/2016
125
