For input capture, the buffer register and the corresponding CCx act like a FIFO. When CCx is empty or
read, any content in CCBUFx is transferred to CCx. The buffer valid flag is passed to set the CCx
interrupt flag (IF) and generate the optional interrupt, event or DMA request. CCBUFx register value can't
be read, all captured data must be read from CCx register.
Event Capture Action
The compare/capture channels can be used as input capture channels to capture events from the Event
System or from the corresponding IO pin, and give them a timestamp. The following figure shows four
capture events for one capture channel.
Figure 35-12. Input Capture Timing
events
COUNT
TOP
ZERO
Capture 0
Capture 1
Capture 2
Capture 3
The TC can detect capture overflow of the input capture channels: When a new capture event is detected
while the Capture Interrupt flag (INTFLAG.MCx) is still set, the new timestamp will not be stored and
INTFLAG.ERR will be set.
Period and Pulse-Width (PPW) Capture Action
The TC can perform two input captures and restart the counter on one of the edges. This enables the TC
to measure the pulse width and period and to characterize the frequency
f
and duty cycle of an input
signal:
� = 1�
dutyCycle =
�
�
�
Atmel SAM L22G / L22J / L22N [DATASHEET]
Atmel-42402E-SAM L22G / L22J / L22N_Datasheet_Complete-07/2016
756
