Value
Description
0
The Generator is stopped in Standby and the GCLK_IO pin state (one or zero) will be
dependent on the setting in GENCTRL.OOV.
1
The Generator is kept running and output to its dedicated GCLK_IO pin during Standby
mode.
Bit 12 – DIVSEL: Divide Selection
This bit determines how the division factor of the clock source of the Generator will be calculated from
DIV. If the clock source should not be divided, DIVSEL must be 0 and the GENCTRLn.DIV value must be
either 0 or 1.
Value
Description
0
The Generator clock frequency equals the clock source frequency divided by
GENCTRLn.DIV.
1
The Generator clock frequency equals the clock source frequency divided by
2^(GENCTRLn.DIV+1).
Bit 11 – OE: Output Enable
This bit is used to output the Generator clock output to the corresponding pin (GCLK_IO), as long as
GCLK_IO is not defined as the Generator source in the GENCTRLn.SRC bit field.
Value
Description
0
No Generator clock signal on pin GCLK_IO.
1
The Generator clock signal is output on the corresponding GCLK_IO, unless GCLK_IO is
selected as a generator source in the GENCTRLn.SRC bit field.
Bit 10 – OOV: Output Off Value
This bit is used to control the clock output value on pin (GCLK_IO) when the Generator is turned off or the
OE bit is zero, as long as GCLK_IO is not defined as the Generator source in the GENCTRLn.SRC bit
field.
Value
Description
0
The GCLK_IO will be LOW when generator is turned off or when the OE bit is zero.
1
The GCLK_IO will be HIGH when generator is turned off or when the OE bit is zero.
Bit 9 – IDC: Improve Duty Cycle
This bit is used to improve the duty cycle of the Generator output to 50/50 for odd division factors.
Value
Description
0
Generator output clock duty cycle is not balanced to 50/50 for odd division factors.
1
Generator output clock duty cycle is 50/50.
Bit 8 – GENEN: Generator Enable
This bit is used to enable and disable the Generator.
Atmel SAM L22G / L22J / L22N [DATASHEET]
Atmel-42402E-SAM L22G / L22J / L22N_Datasheet_Complete-07/2016
136
