Atmel ATSAML22G16A-AUT, Manual

Page: 650 / 1231

33.6.2.4. Data Register
The SPI Transmit Data register (TxDATA) and SPI Receive Data register (RxDATA) share the same I/O
address, referred to as the SPI Data register (DATA). Writing DATA register will update the Transmit Data
register. Reading the DATA register will return the contents of the Receive Data register.
33.6.2.5. SPI Transfer Modes
There are four combinations of SCK phase and polarity to transfer serial data. The SPI data transfer
modes are shown in
SPI Transfer Modes (Table) and SPI Transfer Modes (Figure) .
SCK phase is configured by the Clock Phase bit in the CTRLA register (CTRLA.CPHA). SCK polarity is
programmed by the Clock Polarity bit in the CTRLA register (CTRLA.CPOL). Data bits are shifted out and
latched in on opposite edges of the SCK signal. This ensures sufficient time for the data signals to
stabilize.
Table 33-3. SPI Transfer Modes
Mode CPOL CPHA Leading Edge Trailing Edge
0 0 0 Rising, sample Falling, setup
1 0 1 Rising, setup Falling, sample
2 1 0 Falling, sample Rising, setup
3 1 1 Falling, setup Rising, sample
Note:
Leading edge is the first clock edge in a clock cycle.
Trailing edge is the second clock edge in a clock cycle.
Atmel SAM L22G / L22J / L22N [DATASHEET]
Atmel-42402E-SAM L22G / L22J / L22N_Datasheet_Complete-07/2016
650