24.6.8.2. Early Warning
The Early Warning interrupt notifies that the WDT is approaching its time-out condition. The Early
Warning interrupt behaves differently in Normal mode and in Window mode.
In Normal mode
, the Early Warning interrupt generation is defined by the Early Warning Offset in the
Early Warning Control register (EWCTRL.EWOFFSET). The Early Warning Offset bits define the number
of CLK_WDT_OSC clocks before the interrupt is generated, relative to the start of the watchdog time-out
period.
The user must take caution when programming the Early Warning Offset bits. If these bits define an Early
Warning interrupt generation time greater than the watchdog time-out period, the watchdog time-out
system reset is generated prior to the Early Warning interrupt. Consequently, the Early Warning interrupt
will never be generated.
In window mode
, the Early Warning interrupt is generated at the start of the open window period. In a
typical application where the system is in sleep mode, the Early Warning interrupt can be used to wake up
and clear the Watchdog Timer, after which the system can perform other tasks or return to sleep mode.
If the WDT is operating in Normal mode with CONFIG.PER = 0x2 and
EWCTRL.EWOFFSET = 0x1, the Early Warning interrupt is generated 16
CLK_WDT_OSC clock cycles after the start of the time-out period. The time-out system
reset is generated 32 CLK_WDT_OSC clock cycles after the start of the watchdog time-
out period.
Atmel SAM L22G / L22J / L22N [DATASHEET]
Atmel-42402E-SAM L22G / L22J / L22N_Datasheet_Complete-07/2016
318
