ABB Relion 611 Series, Technical Manual

Page: 259 / 536

Phase
selection
logic
BLOCK
OPERATE
START
Level
detector t
Timer
t
U_A_AB
U_B_BC
U_C_CA
Blocking
logic
GUID-D71B1772-3503-4150-B3FE-6FFD92DE5DB7 V2 EN
Figure 121: Functional module diagram
Level detector
The fundamental frequency component of the measured three-phase voltages are
compared phase-wise to the set value of the
Start value setting. If the measured value
is higher than the set value of the Start value setting, the level detector enables the
phase selection logic module. The Relative hysteresis setting can be used for
preventing unnecessary oscillations if the input signal slightly differs from the Start
value setting. After leaving the hysteresis area, the start condition has to be fulfilled
again and it is not sufficient for the signal to only return to the hysteresis area.
The Voltage selection setting is used for selecting phase-to-earth or phase-to-phase
voltages for protection.
For the voltage IDMT operation mode, the used IDMT curve equations contain
discontinuity characteristics. The
Curve Sat relative setting is used for preventing
undesired operation.
For a more detailed description of the IDMT curves and the use of the
Curve Sat Relative setting, see the IDMT curve saturation of the over
voltage protection section in this manual.
Phase selection logic
If the fault criteria are fulfilled in the level detector, the phase selection logic detects
the phase or phases in which the fault level is detected. If the number of faulty phases
match with the set
Num of start phases , the phase selection logic activates the Timer.
Timer
Once activated, the Timer activates the
START
output. Depending on the value of the
set Operating curve type , the time characteristics are selected according to DT or
IDMT.
For a detailed description of the voltage IDMT curves, see the IDMT
curves for overvoltage protection section in this manual.
1MRS757454 D
Section 4
Protection functions
611 series 253
Technical Manual