Hitachi Compute Blade 2000, Руководство пользователя

Страница: 1719 / 1927

1668
1
3
S
yst
em
O
p
er
at
ion and Man
agem
ent
(b) moduleStatusMm group (1/7)
This group consists of three tables: mmStatusTable for the entire information on
the management module, mmVoltageTable for the voltage sensor information on
the management module, and mmTemperatureTable for the temperature sensor
information on the management module
No
Object
identifier
OID Syntax Access Description
1 moduleStatus
Mm .1.3.6.1.4.1.1
16.5.39.3.3 Not-
Accessible NA Shows the management
module status.
2 mmStatusTabl
e .1.3.6.1.4.1.1
16.5.39.3.3.1 Not-
Accessible NA Shows the table of information
on the management module
status.
3 mmStatusEntr
y .1.3.6.1.4.1.1
16.5.39.3.3.1
.1 Not-
Accessible NA Shows the table entry
describing the information on
the management module
status.
4 mmStatusInde
x .1.3.6.1.4.1.1
16.5.39.3.3.1
.1.1 Integer32 RO Shows the index value ranging
from 1 to chassisCapacityMm
to identify the table entry.
5 mmStatusSlot
num .1.3.6.1.4.1.1
16.5.39.3.3.1
.1.2 Integer32 RO Shows the management
module slot number
corresponding to the index
shown in #4, ranging from 0 to
chassisCapacityMm–1.
6 mmStatusHeal
thStatus .1.3.6.1.4.1.1
16.5.39.3.3.1
.1.3 INTEGER RO Shows the status of the
management module in the slot
shown in #5. One of the
following messages is shown.
(*1)
1: normal
2: fail
3: unknown
7 mmStatusPow
erStatus .1.3.6.1.4.1.1
16.5.39.3.3.1
.1.4 INTEGER RO Shows the status of the
management module installed
in the slot shown in #5. One of
the following messages is
shown. (*2)
1: power-off
2: power-on
3: unknown
4: booting
5: shutdown
(*1) “unknown” is shown in the process of setting redundancy, or when no management
module is installed or the status cannot be obtained.
(*2) “unknown” is shown when no management module is installed or the status cannot be
obtained. ”power-off” is shown after executing Software Defined Networking (SDN) in
the process of setting redundancy.
(*3) “0” is shown as the number of sensor when no management module is installed.
(*4) “Not install” is shown if no management module is installed or redundancy setting is on
the process; “Cannot get data” is shown if the data cannot be obtained.
(*5) “0” is shown if no management module is installed or redundancy setting is on the
process, if the data cannot be obtained, or if no sensor exists.
(*6) “invalid” is shown if no management module is installed or redundancy setting is on the
process; “unknown” is shown if no data is obtained”.