YOKOGAWA UTAdvanced Series, User Manual

Page: 189 / 866

6-88
IM 05P07A01-01EN
6.4 UT55A/UT52A/UP55A D Registers
Output Setting (D5301 to D5400)
Register
No.
Description Range and meaning of value
D5301 OT.H Heating-side control output selection
0: OFF
1: OUT terminals (voltage pulse)
2: OUT terminals (current)
3: OUT terminals (relay)
4: OUT2 terminals (voltage pulse)
5: OUT2 terminals (current)
6: OUT2 terminals (relay)
When the UTAdvanced parameter is set by key stroke,
the heating-side control output selection, and cooling-side
control output selection comprise one parameter.
D5302 OT.C Cooling-side control output selection
D5303
CT
Control output cycle time
Heating-side control output cycle
time (in Heating/cooling control) 0.5 to 1000.0 s
D5304 CTc
Cooling-side control output cycle
time
D5305 to D5310
D5311
V.AT Automatic valve position adjustment
0: O FF (Stop automatic adjustment)
1: O N (Start automatic adjustment)
D5312 V.RS Valve position setting reset
0: OFF
1 : ON (Resets the valve adjustment settings and causes
the indication “V.RS” to blink.)
D5313 V.L Fully-closed valve position setting
Pressing the SET/ENTER key with valve position set
to the fully-closed position by Down arrow key causes
the adjusted value to be stored. When V.L adjustment is
complete, V.L stops blinking.
D5314 V.H Fully-opened valve position setting
Pressing the SET/ENTER key with valve position set to
the fully-opened position by Up arrow key causes the
adjusted value to be stored. When V.H adjustment is
complete, V.H stops blinking.
D5315 TR.T Valve traveling time 5 to 300 s
D5316 V.MOD Valve adjusting mode
0: V alve position feedback type
1: V alve position feedback type (moves to the estimating
type if a feedback input error or break occurs.)
2: V alve position estimating type
D5317 to D5320
D5321 RTS Retransmission output type of RET
0: OFF (Disable)
1: P V1 (PV)
2: SP1 (SP)
3: O UT1 (OUT (Valve opening: 0 to 100 % in Position
proportional control))
4: L PS (15 V DC loop power supply)
5: P V2 (Loop-2 PV)
6: SP2 (Loop-2 SP)
7: OUT2 (Loop-2 OUT)
8: TSP1 (Target SP)
9: HOUT1 (Heating-side OUT)
10: COUT1 (Cooling-side OUT)
11: MV1 (Position proportional output (internal computed
value))
12: TSP2 (Loop-2 target SP)
13: HOUT2 (Loop-2 heating-side OUT)
14: COUT2 Loop-2 cooling-side OUT
15: MV2 (Loop-2 position proportional output (internal
computed value))
16: PV (PV terminals analog input)
17: RSP (RSP terminals analog input)
18: AIN2 (AIN2 terminals analog input)
19: ANI4 (AIN4 terminals analog input)
Loop-2 setting values are unavailable in Single-loop
control.