
1. Install the crankshaft pulley, washer, and
SST
to the crankshaft.
Fig. 50: Installing Crankshaft Pulley, Washer, And SST To Crankshaft
Courtesy of MAZDA MOTORS CORP.
2. Tighten the
SST
nut and install the crankshaft pulley.
Fig. 51: Tightening Crankshaft Pulley Nut
Courtesy of MAZDA MOTORS CORP.
CRANKSHAFT PULLEY LOCK BOLT INSTALLATION NOTE
1. Set a flathead screwdriver to the drive plate in the position indicated in the figure to lock the crankshaft
rotation.
2. Tighten the new crankshaft pulley lock bolt in four steps.
1. Tighten to
120 N.m {12.2 kgf.m, 88.5 ft.lbf}.
2. Loosen
360°
(one full turn) in reverse order.
3. Tighten to
47-53 N.m {4.8-5.4 kgf.m, 35-39 ft.lbf}.
4. Tighten
85° - 95°.
3. Install the starter. (see
STARTER REMOVAL/INSTALLATION [MZI-3.5]
.)
NOTE:
z
Lubricate the contact surface (exterior area of inner diameter) of the front
oil seal with clean engine oil.
2007 Mazda CX-9 Grand Touring
2007 ENGINE Mechanical (MZI-3.5) - CX-9
Microsoft
Sunday, November 15, 2009 9:19:27 AM
Page 35
© 2005 Mitchell Repair Information Company, LLC.