Fig. 3: Starter Circuit Diagram
MAGNETIC SWITCH OPERATION INSPECTION
Pull-out test
1. Verify that the starter motor pinion is extended while battery positive voltage is connected to terminal S
and the starter body is grounded.
z
If the starter motor pinion is not extended, repair or replace the starter.
Fig. 4: Connecting Battery Positive Voltage To Terminal S And Ground
Return test
1. Disconnect the motor wire from terminal M.
2. Connect battery positive voltage to terminal M and ground the starter body.
3. Pull out the drive pinion with a screwdriver. Verify that it returns to its original position when released.
z
If it does not return, repair or replace the starter.
NOTE:
z
Depending on the battery charge condition, the starter motor pinion may
rotate while in an extended state. This is due to current flowing to the
starter motor through the pull-in coil to turn the starter motor, and does
not indicate an abnormality.
2007 Mazda CX-9 Grand Touring
2007 ENGINE Starting System (MZI-3.5) - CX-9
Microsoft
Sunday, November 15, 2009 9:28:57 AM
Page 3
© 2005 Mitchell Repair Information Company, LLC.
