5. After completion of repairs, clear all DTCs stored in the PCM, while referring to "AFTER REPAIR
PROCEDURE".
Fig. 10: Identifying DLC-2 Connector
Courtesy of MAZDA MOTORS CORP.
OBD-II DRIVE MODE [MZI-3.5]
z
The following procedure is designed to execute and complete the OBD-II monitors and to clear the DTC
P1000.
z
To complete a specific monitor for repair verification, follow Steps 1 through 4, then continue using the
steps indicated by the appropriate monitor.
z
The Drive Mode is performed using the M-MDS.
CAUTION:
z
While performing the Drive Mode, always operate the vehicle in a safe
and lawful manner.
z
When the M-MDS is used to observe monitor system status while
driving, be sure to have another technician with you, or record the
data in the M-MDS using the PID/DATA MONITOR AND RECORD
function and inspect later.
NOTE:
z
If the OBD-II system inspection is not completed during the Drive Mode,
the following causes are considered:
{
The OBD-II system detects a malfunction.
{
The Drive Mode procedure is not completed correctly.
z
Disconnecting the battery will reset the memory. Do not disconnect the
battery during and after Drive Mode.
z
The M-MDS can be used at anytime through the course of the Drive Mode
to monitor the completion status. Monitoring can be done by viewing the
ON BOARD SYSTEM READINESS menu.
z
Most OBD-II monitors will complete more readily using a "steady foot"
driving style during cruise or acceleration. Operating the throttle in a
"smooth" fashion will minimize the time required for monitor completion.
2007 Mazda CX-9 Grand Touring
2007 ENGINE PERFORMANCE On-Board Diagnostic (MZI-3.5) - CX-9
Microsoft
Sunday, November 15, 2009 9:26:28 AM
Page 11
© 2005 Mitchell Repair Information Company, LLC.
