Safety Instructions
Safety Instructions
for design process
Safety Instructions
on installation process
I/O signal or communication line shall be wired at least 100mm
away from
a high-voltage cable or power line.
Fail to follow this instruction may cause
malfunctions from noise
Caution
Use PLC only in the environment specified in PLC manual or general standard of
data sheet.
If not, electric shock, fire, abnormal operation of the product may be caused.
Before
install or remove the module, be sure PLC power is off.
If not, electric shock or
damage on the product may be caused.
Be sure that every module is securely attached after adding a module or an
extension connector.
If the product is installed loosely or incorrectly, abnormal
operation, error or dropping may be caused. In addition, contact failures under poor cable
installation will be causing malfunctions as well.
Be sure that screws get tighten securely under vibrating environments.
Fail to do so
will put the product under direct vibrations which will cause electric shock, fire and
abnormal operation.
Do not come in contact with conducting parts in each module
, which may cause
electric shock, malfunctions
or abnormal operation.
Caution
Summary of Contents for XBF-PN04B
Page 1: ...Programmable Logic Controller Positioning Module EtherCAT XGB Series XBF PN04B XBF PN08B ...
Page 626: ...Chapter 9 Functions BPS37 setup RS232 and PC connection BPS37 option board LED 9 193 ...
Page 796: ...Appendix3 Dimension A3 1 Appendix 3 Dimension Appendix 3 1 Dimension of XBF PN04B PN08B ...