Lantronix x6010, User Manual

Page: 115 / 261

Lantronix ION x6010 User Guide
33493 Rev. F https://www.lantronix.com/ Page 115 of 261
Command
: Set DMI Receive Power Preset Level
Syntax :
set dmi rx–power–preset–level
=<x> ??
Description : Defines a fiber port’s current RX power threshold.
Where x = <0-10>
Example :
C1|S4|L1D>
set dmi ?
rx-power-preset-level
C1|S4|L1D>
set dmi rx-power-preset-level 5
Error: this command should be executed on a port!
C1|S4|L1D>
go l1p=1
C1|S4|L1P1>
set dmi rx-power-preset-level 5
DMI is only supported on FIBER port!
C1|S4|L1P1>
go l1p=2
C1|S4|L1P2>
set dmi rx-power-preset-level 5
C1|S4|L1P2>
Note
: use the
show dmi info
command to display the current Diagnostic monitoring interface
information.
Command : Set TDM Loopback Operation
Syntax :
set tdm loopback operation
=<init|stop> <cr>
Description : Defines the current port’s TDM loopback operating configuration to either
init
(start) or
stop
.
Example
:
C1|S4|L1P2>
set tdm ?
loopback
C1|S4|L1P2>
set tdm loopback ?
oper
type
C1|S4|L1P2>
set tdm loopback oper ?
init
stop
C1|S4|L1P2>
set tdm loopback oper init
C1|S4|L1P2>
set tdm loopback oper stop
C1|S4|L1P2>