Lantronix
ION x6010 User Guide
33493 Rev. F
Page 250 of 261
E1 Mode Configuration
1.
Set DIP Switch SW4 switch #4 to the Down position.
2.
Access the x6010 through either a USB connection or a Telnet session.
3.
Use the
go
command to switch to Port 1.
Type
go c=1 s=x l1p=1
.
4.
If required, enter a Circuit ID of up to 64 characters using the
set circuit-ID
command.
5.
Configure Loopback management as required.
Type
set tdm loopback oper
=xx and
set tdm loopback oper type=xx
.
6.
Configure TAOS Transmit.
Type
set taos transmit=enable
.
7.
Verify the E1 mode configuration.
Type
show tdm config
.
For SNMP MIB Trap Information
For information on Network Management for Microsoft Networks Using SNMP, see the
or
http://technet.microsoft.com/en-us/library/cc723469.aspx
The notification MIB is described in section 4.2 and section 7.2 of RFC 2573, available from the IETF web
site at
