Lantronix
ION x6010 User Guide
33493 Rev. F
Page 71 of 261
TDM Mode
– Indicates the type of the current device.
T1=1.544MHz
; T
1=2.048MHz
;
E3=34.4Mb/s
;
DS3 = 44.7Mbps
;
STS-1 = 51.8Mbps
.
Line Build Out
– The characteristics of the T1/E1 card’s copper interface (read only field, e.g.,
e13-0V120ohm
).
Connector Type
–
Dual BNC
,
SFP Slot
, etc. (model dependent – read only field).
Loopback Type
– either “
No Loopback
” or “
PHY layer
” loopback displayed.
Loopback Status
– either “
Local In Loopback
” or “
No Loopback
” displayed.
18.
Verify the x6010
Port 2
(fiber port) configuration settings:
Circuit ID
– either blank or the information entered earlier displays.
Link Status
– either
Down
or
Up
displayed (read only field).
AIS Transmit
– Select
All One
s or
Blue
on the Port 2 fiber interface as an error signal when the
Port 2 fiber interface is down. When this error signal is transmitted, the AIS of the device on the
other end is activated, if supported (read/write field).
Transmit All Ones
– displays the Transmit All Ones status – either
Enabled
or
Disabled
(read
only field).
Alarm Indication Signal
– Either “
Alarm
” or “
Normal
”. When “
Alarm
” displays, this means that
the other end has TAOS enabled and is currently transmitting an alarm condition. When
“
Normal
” displays, this means no alarm (read only field).
Connector Type
–SFP Slot, Dual BNC, etc. – model dependent (read only field).
Loopback Type
– either “
No Loopback
” or “
PHY Layer
” loopback displayed (read/write field).
Loopback Status
– either “
Local In Loopback
” or “
No Loopback
” displayed.
19.
At the DMI tab (if supported and configured) set the
Rx Power Intrusion Threshold
(0-65535
μW). The default is 0 uW
(microwatts).
20.
Click the
Refresh
button and verify the DMI status. See “
DMI (Diagnostic Maintenance Interface)
Test
” for more information.
