Lantronix
ION x6010 User Guide
33493 Rev. F
Page 60 of 261
T1 Ports Configuration
The x60xx ports configuration sets Port 1 and Port 2 Circuit ID, AIS Transmit and TDM Loopback type.
You can configure the x60xx ports via the CLI or the Web interface.
T1
Ports Configuration – CLI Method
The port information can be alphabetic, numeric or a combination. See “
Section 6: Command Line
Interface (CLI) Reference
”
for individual CLI command details.
1.
Access the x60xx through either a USB connection (see “
Starting a USB Session
”) or a Telnet session
(see “
Starting a Telnet Session
”).
2.
Configure the Port 1 Circuit ID. At the command prompt type
set circuit-ID=xx
(up to 64
alphanumeric characters) and press
Enter
.
3.
Configure the Port 1 Loopback Type. Type
set tdm loopback type
=
phylayer
and press
Enter
.
4.
Use the
go
command to switch to Port 2.
5.
Repeat steps 2-3 above to configure the Port 2 Circuit ID, AIS Transmit, and Loopback Type.
6.
Configure the Port 2 DMI function (optional – if supported). See “
DMI (Diagnostic Maintenance
Interface) Test
” for more information.
7.
Click the
Save
button when done. For example:
AgentIII C1|S5|L1P1>
set ais transmit=enable
AgentIII C1|S5|L1P1>
set tdm loopback type=phylayer
AgentIII C1|S5|L1P1>
go l1p=2
AgentIII C1|S5|L1P2>
set ais transmit=enable
AgentIII C1|S5|L1P2>
set tdm loopback type=phylayer
10.
Verify each port’s configuration. For example:
AgentIII C1|S5|L1D>
go l1p=1
AgentIII C1|S5|L1P1>
show tdm port config
link oper status: up
alarm indication signal: normal
taos transmit: enabled
longhaul: no
lbo status: unknown
connector: Dual BNC
AgentIII C1|S5|L1P1>
go l1p=2
AgentIII C1|S5|L1P2>
show tdm port config
link oper status: up
alarm indication signal: alarm
taos transmit: enabled
connector: SFP Slot
AgentIII C1|S5|L1P2>
