
Lantronix
ION x6010 User Guide
33493 Rev. F
Page 37 of 261
Starting a USB Session in HyperTerminal
The following describes the procedure to access the NID via a USB connection.
1.
Start the terminal emulator program (e.g., HyperTerminal).
2.
When the emulator screen displays, press
Enter
. The login prompt displays.
If the login prompt does not display, try unplugging and re-plugging the USB cable at the
IONMM.
Note
: If your system uses a security protocol (e.g., RADIUS, etc.), you must enter the login and
password required by that protocol.
3.
Type your login (the default is
ION
).
Note:
the login is case sensitive.
4.
Press
Enter
. The password prompt displays.
Note:
if a “
Login incorrect
” message displays,
ignore it.
5.
Type your password (the default is
private
).
Note:
the password is case sensitive.
6.
Press
Enter
. The HyperTerminal command line prompt displays.
7.
Enter a
go
command to change the location for the command prompt. The
go
command format
is:
go [c=CHASSIS] [s=SLOT] [l1ap=PORT] [l2ap=PORT] (l1p=PORT|l2p=PORT|l3p=
PORT|l1d|l2d|l3d)
8.
Enter commands to set up the various configurations for the NID. For configuration information,
see “
Section 4: Configuration”
. For a description of all available CLI commands see “
Section 6:
Command Line Interface (CLI) Reference”.
Note
: If required by your organization’s security policies and procedures, use the CLI command
set
community write=<xx>
to change the default password.
For a description of all available CLI commands
see “
Section 6: Command Line Interface (CLI) Reference”.