Lantronix x6010, User Manual

Page: 26 / 261

Lantronix ION x6010 User Guide
33493 Rev. F https://www.lantronix.com/ Page 26 of 261
Config Switch 12345678
– DIP Switch
SW3
and
SW4
Switch 3-1 Line configuration setting in T1 mode (see table below).
Switch 3-2 Line configuration setting in T1 mode (see table below).
Switch 3-3 Line configuration setting in T1 mode (see table below).
Switch 3-4 Inband loopback selection:
•
Up: Disabled (default)
•
Down: Enabled
Switch 4-1 TAOS on copper port:
•
Up: Disabled (default)
•
Down: Enabled
Switch 4-2 TAOS on fiber port:
•
Up: Disabled (default)
•
Down: Enabled
Switch 4-3 Long haul or short haul mode (only valid for T1 mode):
•
Up: Short haul (default)
•
Down: Long haul
Switch 4-4 T1/E1 mode selection:
•
Up: T1 mode (default)
•
Down: E1 mode (cable configuration is automatically set to 120 ohms)
SW4-4: up, SW4-3: up. T1/Short Haul (SW3-4 is not used in Short Haul mode):
SW3-1 SW3-2 SW3-3 DSX-1 Condition
Up Up Up J1 Mode, 110 ohm cable (Optional)
Up Up Down DSX-1, 162.5-200m,(533-655’) 100 ohm cable
Up Down Up DSX-1, 121.6-162.5m,(399-533’) 100 ohm cable
Up Down Down DSX-1, 81-121.6m,(266-399’) 100 ohm cable
Down Up Up DSX-1, 40.5-81m,(133-266’) 100 ohm cable
Down Up Down DSX-1, 0-40.5m,(0-133’) 100 ohm cable
Down Down X Do Not Care
SW4-4: Up, SW4-3: Down. T1/ Long Haul (SW3-3, SW3-4 are not used in Long Haul mode):
SW3-1 SW3-2 DS-1 Condition
Up Up -22.5db 100ohm cable
Up Down -15.0db 100ohm cable
Down Up -7.5db 100ohm cable
Down Down 0.0db 100ohm cable
See “ Section 4: Configuration ” for more configuration information.
See “ Appendix B: Factory Defaults ” for a summary of default and optional settings.