Lantronix
ION x6010 User Guide
33493 Rev. F
Page 166 of 261
Fail to set card entity index!
At one time we can only backup at most 10 cards!
At one time we can only restore at most 10 cards!
Backup finished
Error: this command should be executed on a device!
Error: this command should be executed on IONMM or a standalone SIC!
Fail to set card entity index!
Processing...
The MAX provision configure file name is 64!
The specified module does not exist!
You entered a “
prov
” command to do a Backup or Restore function, but a problem was encountered or
the process is not yet finished.
1.
Wait a few moments for the command to complete and the “
Restore finished
” or “
Backup finished
“
message to display.
2.
Retry the backup or restore operation with 10 or fewer devices listed.
3.
Use the
go
command to switch to the device level of a supported device and re-enter the command.
4.
Enter a filename of 64 characters or less in length.
5.
Specify an existing module name.
6.
If the problem persists, contact Technical Support.
Cannot get dot1bridge state on this port!
Cannot set administrate state on this port!
Cannot set advertisement capability on this port!
Cannot set default VLAN id on this port!
Cannot set Ether port duplex mode on this port!
Cannot set pause on this port!
Cannot set VLAN network tagging on this port!
Cannot show VLAN tag config on this port!
Fail to get port type!
You entered a command not supported on the C6120 TP port.
1.
Either use a different (supported) command, or change to another NID that supports the desired
function.
2.
If the problem persists, contact Technical Support.
