Lantronix
ION x6010 User Guide
33493 Rev. F
Page 155 of 261
Cannot set 1000M speed for this card!
You tried to use the
set ether speed
command to set the device’s speed to 1000 Mbps (1 Gbps), but the
card you entered the command on does not support this speed. For example:
C1|S16|L1P1>
set ether speed=1000M
Can not set 1000M speed for this card!
C1|S16|L1P1>
1.
Use the
set ether speed ?
command to determine the card’s speed capabilities.
2.
Re-enter the
set ether speed= command
with a speed supported by the card.
3.
Use another (supported) command, or use the go command to switch to a device that supports this
function.
4.
If the problem persists, contact Technical Support.
Set Ethernet port loopback type failed.
You tried to use the
set oam loopback type
command to set the device’s type of loopback support, but
the command was not accepted. For example:
C1|S16|L1P1>
set oam loopback type=phylayer
Set Ethernet port loopback type failed.
C1|S16|L1P1>
1.
Verify the command syntax.
2.
Use another (supported) command, or use the go command to switch to a device that supports this
function.
3.
If the problem persists, contact Technical Support.
Cannot show system information on this card!
You entered the
show system information
command from an unsupported device. For example:
C1|S22|L1D>
show system information
Cannot show system information on this card!
1.
Try using the
show card info
command.
2.
Use the
go
command to switch to a different device (e.g., from the Power Supply to the IONMM or
an x6010 card).
3.
If the problem persists, contact Technical Support.
L2CP is not supported on this card!
You tried to perform an L2CP function but the device does not support L2CP.
1.
Make sure this is the command / function that you wanted.
2.
Use the
go
command to switch to a device that supports L2CP.
3.
Try entering the command again. See “Configuring L2CP”.
4.
If the problem persists, contact Technical Support.
