Lantronix
ION x6010 User Guide
33493 Rev. F
Page 132 of 261
USB connection resets after a CLI command is executed
1.
If you can connect to the IONMM through the Web interface (see
“Starting the Web Interface”
), go
to step 4 of “
Telnet connection is lost after a CLI command is executed
”.
If you cannot connect to the IONMM through the Web interface, continue with step 2 below.
2.
Check the following:
•
the IONMM is seated properly in the chassis
•
the IONMM is powered up
•
the network cable is seated
•
the network is operational
3.
For all modules (slide-in and remote) check the following:
•
the module is properly seated/connected
•
the module is powered up
4.
Cycle power for the module in question.
5.
If the problem persists, contact Technical Support.
Configuration Mode Mismatch
On the device
MAIN
tab, in the
System Configuration
section in the
Configuration Mode
box, the mode
displayed does not match the hardware setting on the device.
The device may have a jumper or switch that disables software management of the device. When
Configuration Mode is
hardware
, the devices take some of the configurations from DIP switches or
jumpers on the device. In
software
mode, configuration is controlled by management.
1.
Refer to the “
DIP Switches and Jumper Settings
”
section for details on hardware mode
configuration.
2.
Contact Lantronix for more information.
