Lantronix
ION x6010 User Guide
33493 Rev. F
Page 162 of 261
TDM config is not supported on this card!
You entered the command to configure TDM, but the command is not functional on the NID model.
1.
Use the
show tdm config
command to display the current config settings.
2.
Either use a different (supported) command, or change to another NID card that supports the TDM
function.
3.
If the problem persists, contact Technical Support.
TDM port config is not supported on this card!
You entered the command to configure TDM, but the command is not functional on the port.
1.
Use the
show tdm config
command to display the current config settings.
2.
Either use a different (supported) command, or change to another port that supports the TDM
function.
3.
If the problem persists, contact Technical Support.
Set tdm port loopback operation failed
You enabled the loopback function on both copper and fiber ports at same time, which is not allowed.
1.
Make sure the LOAM Admin state for this port is enabled (active). See the
set loam admin state
command.
2.
Make sure LOAM is enabled on both ends of the link.
3.
Enable the loopback function on either the copper port or the fiber port (but not both ports at the
same time).
Set port TAOS Status Failure!
You entered the command to configure TAOS, but the command is not functional on this x6010 port.
1.
Use the
show taos config
command to display the current config settings.
2.
Either use a different (supported) command, or change to another NID port that supports the TAOS
function.
3.
If the problem persists, contact Technical Support.
